Anycubic Photon Printer Owners 造訪社團 » 用戶發文

when sealing/priming prints. are you doing it just for UV protection? i mean could you do a clear seal/prime?

翻譯年糕

Does leaving print sitting in ipa for an extended period of time hurt the print? I was cleaning the print of in an ultra sonic cleaner and forgot about them for like 4 hours. Came back and they are very soft like rubber. Softer than when I took them off the print bed. But they are hardening up when put into uv chamber

翻譯年糕

Hoping this lasts me a while ?

翻譯年糕

Anyone experience photon just stopping a print and going back to main screen? Like the controller just restarted itself? I wasn’t near it when it happened but prolly 3hrs into a 5hr print I come back and photon is at the main screen and platform was sitting at the top of the lift arc

翻譯年糕

Anyone know kw/h usage for photon?

翻譯年糕

Looks like the prints came out good, but still experiencing some support failures as seen on right center ? . Using wanhao green .05/20/1/60/8 any suggestions

翻譯年糕

Question about printing miniatures: should I be tilting models to 45 degrees or is it just a preference?

翻譯年糕

Can anyone share a link to the spreadsheet/gsheet that’s has been referenced in a few posts. I would be very greatefull ? . I’ve been printing the dnd manual ( shapeways mz4250) and minis from Ill gotten games/ Dutch mogul.

翻譯年糕