Anycubic Photon Printer Owners 造訪社團 » 用戶發文

What is the type of this problem?

I use funtodo Resin industrial red.

Printer settings: layer 0,040, exposure time 12, Off time 2

Thanks

翻譯年糕

Hi
I wanted some advice and share the problem that happens with the prints and understand if someone else happened.
Usually I try to print small mechanical parts, I bought the printer a few months ago but I could not get qualitative prints as it was too cold and the resin was too viscous (I have the printer in the basement), With the spring season and the 'arrival of the heat I started to do some more tests but it happens I find myself with the problem that in the "sub-squares" where there are the bridges to the base of the platform, the part is not defined, it seems almost to cure the resin in more creating a rough and inaccurate surface, I have tried various inclinations but the problem persists and I had it both with resin anycubic and with the one I'm using now. Wanhao
I used the values ​​on the sheet in Drive (Anycubic Photon Resin Settings).
I can not understand if it's a matter of resin or anything else, seeing the other prints on the group seem much more qualitative than mine.
Thank you

翻譯年糕