Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anycubic has published the firmware 4.2.18 for classic Photon. It is available at their website.

翻譯年糕

Any advice on a clear resin that stays clear (not yellowing under sun)? I heard of Photocentric, but don't know if it really keeps clear after extended exposure to UV, and its only available on 1Kg bottles that is too much for only trying.

翻譯年糕

Could someone test the following file? My printer cuts around 4mm in Y axle and 2mm in X axle, and I don't know if this is normal or can be fixed with a newer version of firmware. The main problem is that slicer do not provide any warning.
As you can see the STL file contains an elipse that fills the entire active area (120,96mmx68,04mm). The slicer does not show red walls and slice preview is OK, but when printed the edges are cut.
Is also possible to test with a dry run checking if the LCD shows the full elipse or it is cutted.

翻譯年糕

Could any of the users that receive a replacement motherboard post a good quality photo of the Photon motherboard? I'm curious about the hardware used and the Z-motor related issues some users experienced.
Thank you!

翻譯年糕

Anycubic has updated its slicer to version 1.3.6. It's available now on the support page for the Photon.

翻譯年糕

Has someone used FTD IB clear? While it works fine the models I get have a yellowish tint (the resin looks clear, but the models are light yellow after print (no post-curing made)). Is this normal? Is there any way to avoid this yellow tint?

翻譯年糕

Is this caused by the power supply?
It was a 5+ hours print, but it finished around 50% (it can be seen in the display the remaining time and progress bar, but printer stopped and reported job finished). Besides the build platform had not rise to the end position, the last layer was still stuck to the FEP when I manually moved the platform up.

翻譯年糕

Hello, I recently bought this printer and noticed that the estimated print time provided by the slicer is around a 30% lower than the real printing time. Is this normal or my printer is slower than intended? Can the time be tweaked in the slicer so ti is more accurate? (It looks like the sclicer is not taking into account the retraction time for each layer, only the exposure and pause intervals).

翻譯年糕