Hey guys! Been reading this forum like mad the last few days to try and solve my issue. I've also contacted Anycubic as well.
I've leveled and printed the test cube - came out great.
I've printed a couple prints for myself - came out great.
I went to go print another print and....nothing. I thought it was odd and set it going again but I stayed in the room to check. I noticed that when the print plate went down into the resin vat (with resin in it) there was a LOT of beeping. I had never noticed that before. The printing plate stayed in the resin and didn't move. I looked at the LCD screen and it showed me the first layer it was going to print and then there was just nothing. It didn't show the estimated print time or even the layers. What I was printing had 912 layers and it showed 0/912.
So I read the forum.
I leveled my print plate.
I cleaned my resin vat - nothing on the FEP (film, cloudy, dents)
I cleaned my LCD screen - nothing on it.
My resin is the AnyCubic green they give you.
I tried the only have one print job on the USB stick.
I've tried the unplug and plug in the USB and the power plug.
I've tried the dedicated power source.
I've tried a new USB stick - formatted in FAT32, copied the files, safely removed - got memory error.
Anycubic said to do a new USB stick and that they'd get back to me on Tuesday due to Chinese Holidays.
What am I missing?
I have seen it might be my power supply, my mother board, or a corruption in my files. Did I miss someone posting the new file for the USB stick?
翻譯年糕
