Hi everyone. I have a problem with the printer.
I tried to run the .photon file on 3 printers (even with different firmware) but we see that the image is broken down and distorted. The Stl file is not because analyzed by Netfabb, it says that it is correct. The problem arises only on some layers as if it could not compose the layer image. It happens with different Stl, while with others it prints without problems. As if he had some difficulty with the memory of images. Computer and touchscreen screen images are correct.Who has the new firmware rewritten and wanted to do a test send him the photon file, I'm sure it's a firmware problem.
In the photos you can clearly see what happens.
翻譯年糕
Mike Cousins
2019-04-24 01:33:25
Luca Perry
2019-04-24 01:39:42
Mike Cousins
2019-04-24 01:55:54
Luca Perry
2019-04-24 02:01:19
Bob Deblier
2019-04-24 02:40:38
Luca Perry
2019-04-24 03:02:08
Luca Perry
2019-04-24 03:02:08
Luca Perry
2019-04-24 17:43:18
Bob Deblier
2019-04-24 17:44:33
Luca Perry
2019-04-24 17:46:15
Bob Deblier
2019-04-24 17:49:00
Luca Perry
2019-04-24 17:51:41
Bob Deblier
2019-04-24 17:53:51
Luca Perry
2019-04-24 17:55:57
Bob Deblier
2019-04-24 17:58:33
Luca Perry
2019-04-24 18:00:34
Bob Deblier
2019-04-24 18:45:52
Mike Cousins
2019-04-24 19:48:28
Vinicius Silva
2019-04-24 20:30:23
