Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Ok, quick question, I've adjusted my z carraige for the third time to try to eliminate z- wobble and it seemed pretty tight, no play in any direction, now that I've re-assembled and attached the build plate there's now quite a lot of play back and forth and side to side.
Can anyone check to see if this is normal or should it be rock solid if you try to move it bt the build plate?

翻譯年糕

Hi, can anyone help me with the correct setting for B9Creator for use with the Photon. The buildplate seems to change size depending on the selected resolution or does it not matter?

翻譯年糕

Wondering if anyone has some advice. I was getting z - banding on my prints at maybe 10 mm intervals so I followed the video and made the adjustments however now I seem to be getting lines at about 1mm intervals and the prints look a bit like FDM prints now. Also it seems to make a dull but quiet knocking noise when the printing plate goes up and down out the vat when printing. What should I adjust?
(Noticed also that the brass disc on my carraige differs from the one in the video as it only has two holes round the centre)

翻譯年糕