Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Reminder that sometimes print failures are caused entirely by bad model geometry during slicing. This one had four distinct topologies and an open edged plane and resulted in the first picture after being sliced in formware, after some massaging in meshmixer I was able to get a successful print out of it.

翻譯年糕

Some bottom layer separation issues but otherwise I’m impressed with the increase in detail for 20 micron layers when I normally print at 50. Resin is the pink AC soy based resin, bottom layers were exposed for 40 seconds and regular layers for 6, do any of y’all have any suggestions for adjusting the print settings? I think I need to increase the quantity of bottom layers and lower the bottom layer expose to maybe 10 or 20 seconds but I’d like to hear your thoughts

翻譯年糕

Finally ran out of purple resin, added pink last night before running this print and the gradient on some of them is pretty neat! Two of the 18 on the build plate didn’t adhere properly in one corner so it’s going to need some TLC this afternoon however.

翻譯年糕

Still getting used to the subtleties of resin printing, this lil guy (From Duncan Louca) came out fine but I rushed the washing process so he has a few pocked marks where there was still a little bit of leftover resin under the UV lamp. I also accidentally snapped the sheath off of his left arm when trimming supports.

翻譯年糕

Moved my setup into the basement because I realized I had easy access to the chimney for ventilation because of the old boiler in the house. Complete with a post processing setup!

翻譯年糕

Hello! I figured I should look at this group because I was having some trouble with first layer adhesion earlier on my new Photon but after some leveling and such it seems to be working better now.

翻譯年糕