So, haven't seen any great discussion of Off Time(s) paramater and the correct setting. When I time what it takes to move the head up and down (when setting is set to 1 sec), it actually takes 4.7-5 secs. This gives a bad estimate on the slicer. When I did the same print but with a 4.7sec off time, I get an accurate estimate in slicer that matches the machine and reality. I think many people are confused that setting that number artificially low actually changes reality, and that is just not the case. The cycle to lift and replace is purely the time it takes the servo motor to move around the build platform.
翻譯年糕
