Third failed attempt. I set it to print a simple shape on a slightly raised structure when I left for work and there was the beginning of a shape with a whole mess of clean up in the vat when I came home for lunch. (I had to leave it for now)
The shape obviously started forming but I can't tell how much was properly done before it fell off the plate.
Are the prints just not sticking to the plate, maybe? Is that common? Could it be something else?
I could really use some advise. The first two prints I did worked fine but now I can't seem to get anything to work. I'll add a picture of the vat mess when I get home tonight if it would help.
翻譯年糕
