Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Best way to print something like this ? I'd ideally like to get as much onto the build plate as possible, so probably printing vertically, but i'm concerned the supports may not be enough to hold it to the plate mid print, i've tried printing direct on that plate, that worked but added some size distortion and would block some of the holes. Is best option to lift the model 5mm and then put a good amount of support below it ? (the model will be hollowed out).

Also, the resin is too brittle for the clips to work properly, they snap rather than bend like fdm abs would, would monocure flex be an option or should i just swap to using magnets and fix the pegs in.

Thanks

翻譯年糕

Anyone got a link to a replacement lcd screen from aliexpress or similar that has had its backlight removed, think i might order one in early to keep as a stock spare

翻譯年糕

First print in Flesh Resin (spreadsheet settings)

翻譯年糕

First print

翻譯年糕

Whats the best way of cleaning the tank between resin colours, is it ok to use IPA to wipe the inside (i.e. it doesnt effect the FEP) then leave to air dry ?
(sorry for all the questions)

翻譯年糕

How long do people put the models into ipa for too clean (is it like 2 mins in, then into water, repeat, then move to uv box) and how long do people leave in uv for ?

Thanks

翻譯年糕

Hi, in prep for my printer arriving later i've downloaded the formware trial and created a profile for the skin resin based on the settings in the spreadsheet (will print test model first) and sliced a model i'll use.

I cant seem to find where to put in the "off timer" in the sheet into formware ?

Anyone who uses it know, attached is screenshots of my settings and first model setup

翻譯年糕

Bit the bullet and purchased, any complete beginner tips please. I.e. What additional software to use, should i use a quick wipe of rain away on the FEP to help (cant get the turtle wax stuff in the uk), how long in IPA, is it just a quick 1-2 min dip, then water, then repeat

翻譯年糕

Thinking of pushing the button and getting the printer (its 400 on amazon with the yellow windows) thinking about getting 2l of a single colour of any cubic resin and using that instead of the 250ml included, is there a particular colour people would recommend for good prints ?

翻譯年糕

What are people's experience of different levels of odour with different resin's. Are there any good low odour resins that work well with anycubic and any resins to avoid that have higher odours

翻譯年糕