Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jimi Vandermost
2018-11-30 11:34:12

Can someone please help me understand what anycubic support means by these instruction? I’m no sure what they are asking......

Please try to insulation treatment between the trough and the machine platform contact surface, may be the cable short circuited due to the static electricity.

After you isolate the groove and the machine platforn contact surface then try again.

翻譯年糕

Sen Kun
2018-11-30 15:02:21

原文網址 Jimi Vandermost
2018-11-16 12:16:49

Hey guys, so when i have been having issues with printing anything lately. It will print the first layer then shut completely off. Have done a bunch of different firmwares from anycubic support and power supplies and flash drives.

When i take the vat and build plate off and just run the printer, it will go through the whole process of printing. But as soon as i ACTUALLY try to print something with the vat and build plate back on. It fails. Could it have something to do with the suction? I notice it fails way more with bigger prints. Any advice is greatly accepted.

翻譯年糕

Dennis Tomson
2018-11-16 13:12:47

Luca Agnelli
2018-11-16 13:33:33

Sen Kun
2018-11-16 14:34:44

原文網址 Jimi Vandermost
2018-10-16 00:16:12

Hey guys, is there anyway to raise the height of the supports? It only seems to be dependent on what thickness you use but i would like to manually adjust the height if possible. Thank you!

翻譯年糕

原文網址 Jimi Vandermost
2018-10-02 23:51:28

So my printer has been working fine for a little over a month now. But i just started getting this error where after the first layer, the printer makes a loud continuous beep, then shuts off and turns back on.

I have updated the firm ware and tried several USB drives. Any suggestions?

翻譯年糕

Vinicius Silva
2018-10-02 23:52:07

Jimi Vandermost
2018-10-02 23:53:07

Vinicius Silva
2018-10-03 00:47:50

Jimi Vandermost
2018-10-03 00:58:49

Alex Danis
2018-10-03 01:16:43