Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Good Morning Everyone,
I am curious what people are using for their cure station timers? I just built a cure box last night finally and would like to be able to set a timer for specific amounts of time. Is their a common one used for this. A lot of the ones I am seeing online are to turn lights on and off over a 24 hour period. Not short cycle stuff.

翻譯年糕

Hello fellow members,
I haven’t used my printer in about a month because I have been busy. After popping in my original usb to the computer it read fine and I transferred the slicer file to it. Then when putting it in the printer, it doesn’t read, and slows the system down. When putting it back into the computer it no longer reads, and asks to be formatted.
I grabbed another I had laying around and formatted it fresh to FAT32. It is doing the same thing. Although this one goes back into the computer fine and reads correctly.
Does anyone have any ideas?

翻譯年糕