Hello photonsters,
A couple of weeks ago I was made aware that are printers were having some failures. Are printers have been running for about 5 months now. 8 to 12 hours a day Monday thru Friday. So I went through all the basic steps to try to trouble shot the problems. When I did the UV test the rectangular on LCD screen didn't look clear. It looked cloudy to me. My thought was LCDs were bad and need to be replaced. So before i did the LCD replacement. I text Vinicius Silva and asked him, Can i replace LCDs and reuse protective glass?" LCDs looks cloudy when doing UV test. I think they need to be replaced. I'm no expert so I thought I would ask a master.
Vinicius replied, What do you mean lcd is cloudy?
cloudy is not a objective term i'm afraid
?
Please share picture.
Funny guys these master photonsters. Lol.
So long story short
We had a dust problem (a bad one) and not a bad LCD problem. They saved me from doing a LCD replacement. Plus i gained a lot of photon knowledge out of all of this. Thanks again.!
It was much easier to air off and clean inside of cone and back of LCD then to replace LCD.
Oh i disconnected the cable from the 3.5 front screen in the second printer. Then closed it up not knowing till you turn on to check. Had to re-open and reconnect cable.
?
Never stop learning!
so here are all the videos and pictures that I shared with Vinicius Silva and Sun Kun throughout the process. Now I'm sharing with all photoners. Keep an eye out for the dust build up! Thanks again!
翻譯年糕
Sen Kun
2019-04-13 18:12:37
Vinicius Silva
2019-04-13 18:41:05
Vinicius Silva
2019-04-13 18:42:13
Kevin Miller
2019-04-13 18:55:50
Vinicius Silva
2019-04-13 18:57:44
