Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Worm Wigs
2019-01-20 01:31:32

Put together this fully articulated doll I finished printing the parts for last night in AnyCubic “Skin”. Some parts could probably do with printing again Cus I got some warping around supports ? . I Sculpted using meshmixer & sculptris ?

翻譯年糕

Kelly Rinaldi
2019-01-20 01:38:13

Chayanin Somton
2019-01-20 01:55:02

Johan Bengtzohn
2019-01-20 01:59:37

Ekaterina Vitalyevna
2019-01-20 03:15:24

Sterling Osment
2019-01-20 08:52:27

Andrew John Monash
2019-01-20 09:09:44

Bradley VanScoyk
2019-01-20 09:42:25

Rhiannon Beorn Van D
2019-01-20 10:08:16

Jason Valdez
2019-01-20 13:46:44

David Howlett
2019-01-20 15:19:43

Frank Abendorf
2019-01-21 03:25:42

原文網址 Worm Wigs
2018-11-30 06:58:50

Hi! Wondering if anyone can help. I've completed two prints on my new Anycubic Photon in the clear green resin it comes with. I wash the prints off in a shallow 70% IPA bath and then rise with plain water and cure with a UV lamp. HOWEVER- the surface of my prints are turning unevenly frosted with patchy white areas after the cleaning process. I'm not sure what I'm doing wrong as I've only seen everyone else have nice clear even coloured prints. Does anybody know what I need to do differently to avoid this?

翻譯年糕

Richard Russell
2018-11-30 07:00:50