UPDATE:
I changed the resin to Anycubic Black. I also formatted the USB stick. One(or both) of these two things seem to have solved the issue.
Has anyone ever seen it do this? Software or hardware?
the first print failed when the screen printed an entire layer as a solid rectangle. when the print was finished the rectangle was stuck to the fep. it was like at a certain point the printer just printed a full exposure of the entire screen and never lifted out of the vat. I tried again on the second print, with a modified version and it looks like it printed a solid rectangle and didn't lift correctly the build plate out of the vat. It printed basically a solid block of resin.
I've reformated the usb stick, and i'm doing a new test print. I'm slicing in Chitubox and i've done more than 10 litres of resin in the past few months without issue.
I did a test of the first layer and it seems to expose correctly, so i'll give it another go and see what happens.
To me it seems like software failing, the screen is exposing correctly and the motor seems to move correctly.
I've put a lot of hours on this machine, but i've never seen anything like this before honestly.
Any thoughts?
翻譯年糕
Ronan Tully
2019-06-23 03:26:53
Mark Wardle
2019-06-23 04:54:48
Mark Wardle
2019-06-23 04:56:59
Colin Graham
2019-06-23 05:37:23
Katarina Dz
2019-06-23 08:15:19
Colin Graham
2019-06-23 08:25:33
Joel Reid
2019-06-23 17:51:49
Spike Walker
2019-06-24 00:29:49
Colin Graham
2019-06-24 21:58:27
