Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi all,
is there a way in Chitubox to add supports at a position that is above another part of the object? In the picture I try to place support at this claw but Chitubox won't let me because it could not place the support at the build plate but would have to connect it to the other part of the object.

翻譯年糕

Hi,

since the last few prints I have a strange problem. Some layers are a bit thicker than the other layers with what seems to be half-cured resin. I can scrape it off afterwards, but the details are gone. On the pictures you can clearly see the areas that had this problem. And that is already after scraping off most of the half-cured resin. On both prints the problem occurred at different layers. After that I did a dry test run to see if the LCD screen has a problem. But I could not see anything strange during the whole print. In the video you can see an example of what it looks like. However in the video it looks like the whole LCD screen is very bright also in the areas that should be dark. This is not the case in reality. You can see a difference between when the LCD is switched off and when it is on, but by far not as extreme as the video suggests.

Do you have any ideas what could cause this problem or has anyone experienced the same problem before? Any suggestions would be much appreciated.

翻譯年糕

Hi, I'm quite new to 3d printing with resin and got a few questions:

1. After cleaning a printed part with IPA and water, is it still toxic until it is fully cured with UV- or sun light?

2. What UV lights could you recommend? Is there a good video out there that has a recommendation how to build a UV curing chamber?

3. The build volume in the photon slicer settings are a bit different from what the printer specifications say. 68.04 x 120.96 x 150 compared to 65 x 115 x 155. Are the settings correct or should they be changed?

翻譯年糕