Hi guys, I just got my printer this week. I successfully printed the test cube. I tried to print out a miniature last night. I used default settings in Photon Slicer for the supplied green resin. I also used auto supports in Chi Tu Box. I was wondering if anyone could take a look at these pictures and can tell if it is too little supports or if I should mess with my support settings.
翻譯年糕
Joel Dawson
2019-01-12 06:50:45
Michael Wright
2019-01-12 06:51:21
Joel Dawson
2019-01-12 06:58:41
Michael Wright
2019-01-12 06:59:29
Joel Dawson
2019-01-12 07:00:21
Richard Shapiro
2019-01-12 07:25:10
Adam Harbinson
2019-01-12 07:26:36
Joel Dawson
2019-01-12 07:26:46
Joel Dawson
2019-01-12 07:28:09
Richard Shapiro
2019-01-12 07:28:52
Adam Harbinson
2019-01-12 07:31:16
Joel Dawson
2019-01-12 07:35:43
Ryan Turner
2019-01-12 07:55:34
Garret Bertrand
2019-01-12 08:01:28
Joel Ligeiro
2019-01-12 08:14:35
Adam Harbinson
2019-01-12 18:09:33
Ben Tseng
2019-01-12 23:23:32
Robert Maefs
2019-01-13 05:17:59
Adam Harbinson
2019-01-13 05:32:43
