Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone tried the ESUN water washable transparent resin? I done on Anycubic Photon: gone very well, I washed and postcured (like somewhere recommended for crystal resins) on UV device under water (a glass). After print result was great, after wash also, after 10min. postcuring was ok, but later, after drying with just compressed air everything was covered by a white dust. (Someone mind theback of some Shapeways ultra frost prints?The same). If you polish the print it gone away.... but I have small lens... hard to be polished. Any know why? Any advice? Thanks.

翻譯年糕

Hi all, I need advice! My Photon is almost 1YO, it printed without big troubles until now, never upgraded firmware (factory one). Last 4 print attempt it stops and switch off the power at approx 10% of print, a "tictac" noise it is noticeable for a few seconds: it happen with different files, after 2nd attempt I also inizialized the USB key: no differences. Anyone got this trouble? Thanks a lot!

翻譯年糕

Leveling action durability!! Finally looks like I get rid of all my start up issues and I'll print on all the build plate, at 50 and even 20 micron of layer. BUT, what I understood is that the print action, and mainly when the layer went detached from the FEP film (with those adorable tiny "stack" that let you hope...) layer after layer move the build plate.... This happen most when you have non-simmetric print area. I observed that my plate went moved of approx 2mm (front was HI 2mm more) after 4-5 prints when I used the back area (at begin I was not able to print front due the build plate crappy machining-coating in such area, so I was used to print back....). Now I'm a strong guy, I think I broken all possible threads in my life building my bikes, I ensure you I close the central screw in the build plate, after leveling, at die..... What happen to you guys? How long a leveling action remains valid, how much prints?? You notice becouse a failure in the areas when the plate is "far" after a few prints.....

翻譯年糕

Hi guys! I'm looking for some help. I have basically now two troubles on the Photon. First one is that the printer works ONLY IN THE TOP AREA (so the half portion versus the back of the printer): base layers won't stich in the front half and eventually also the layers over. Looking at the picture you will see that the layers near the half orizzontal axis aren't melt together and the base layer is very thick: I guess 2 mm thick (thy are 8 base layers of 50 micron...), meantime in the top where the print is well glued to the platform the thickness is maybe 0,5mm or less (in fact...0,4mm nominally...).

No way to print in the front area: you'll findfirst layers stiched to the fep film and nothing on the platform. I changed the LCD due a failure and no changes. Replaced FEP, no changes. Performed several time Z=0 with paper and last time on the FEP, no changes, Sanded down the plaform, no changes. This is the worst issue. The other is that printing at 20micron I haven't the correctZ dimension (lower...), printing at 50 micron Z dimension is correct. Thanks anyone for your precious advices, gio.

翻譯年糕