Problem: print failures are causing internal separations between laminate layers of my FEP film on my Photon's resin tank. First the layers pull apart internally, then a later failure tears the outer layer off. This has happened twice with replacement films purchased through anycubic. I'm not enjoying having to tear down my tank and replace the film after a few prints.
* Is anyone else experiencing this and do you have solutions or work-arounds?
* Am I doing something wrong here? My FEP installs are drum tight.
* Are there FEP films from third party vendors that perform better?
翻譯年糕
Clifford Schwankner
2019-08-04 08:06:59
Todd Jones
2019-08-04 08:07:00
Simon Powell
2019-08-04 08:07:02
Jennell Jaquays
2019-08-04 08:08:50
Todd Jones
2019-08-04 08:09:25
Todd Jones
2019-08-04 08:10:37
Jennell Jaquays
2019-08-04 08:11:00
Jennell Jaquays
2019-08-04 08:11:20
Jennell Jaquays
2019-08-04 08:12:08
Simon Powell
2019-08-04 08:20:03
Jennell Jaquays
2019-08-04 09:39:08
