Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Richard Günter Dölz
2020-02-03 07:08:40

Just replaced the original fans with Gerald Silent Fans. Cannot reccomend this upgrade enough. These fans are SO quiet. And it only cost me £12 for the pair.

Now a few notes on fitting them.

1. Get longer screws.

2. You're gonna have to swap over the connectors. This will mean cutting off the ones from the new fans. Be careful to take note of which wire is which. On the new connectors one of the wires is marked with a "1". This is you're Neuteral wire. The middle wire is the Live. The remaining wire is unnecessary for our purposes and can be removed completely.

翻譯年糕

Thorsten Lüpertz
2020-02-05 03:58:06

原文網址 Richard Günter Dölz
2019-12-16 00:12:08

Just received my Twin Rail upgrade by Simon Jackson . Fantastic work sir, great attention to detail with your packaging and the note for the unaware about the balls being able to escape the linear bearings. Can't wait to get it fitted ?

翻譯年糕

原文網址 Richard Günter Dölz
2019-07-17 03:47:41

Looking for a UK supplier for either Sirayatech Tenacious or Monocure Rapid Flex100

翻譯年糕

Danny Lloyd
2019-07-17 03:52:37

Del Dalton
2019-07-17 03:57:14

Marc Hobden
2019-07-17 06:38:17

Chris Bruce
2019-07-17 06:46:07

原文網址 Richard Günter Dölz
2019-07-14 22:48:37

Here's a puzzler, been printing fine all week, same USB (not the one that comes with the Photon), same slicing software, etc, the file is good, checked the file on the stick after the failure.
as you can see the rear right quarter of the screen is printing fine.
Running Photon 5.5 firmware (EDIT read the wrong line, not sure what version of the firmware i was running).
spent an hour and a half scrolling through this page and didn't come across a similar problem, I know they're on here, just can't find them

EDIT
Updated Firmware to Epax 4.2.18, seems to have fixed the issue.
https://epax3d.com/pages/firmware-and-parameter-files…

翻譯年糕