Hey, new here I have sculpted up a demon type thing in zbrush but am having problems with printing it. You can see the base is kinda warped when it comes out of the printer looks like the Layers are also separating? I just recently got this photon and the layers on the bottom always seem off on every print but it prints the upper layers perfectly. Anyone else have this problem or know a solution I'm lost at this point.
Also I used anycubic grey settings are: .035, 14, 6.5, 90, 8
翻譯年糕
Ricardo Sebastian Ibacache Guerr
2018-12-10 18:48:14
Dre Sahadeo
2018-12-10 20:03:22
Dre Sahadeo
2018-12-10 20:03:40
Savio Ku
2018-12-10 20:12:54
Richard Shapiro
2018-12-10 20:26:00
Richard Shapiro
2018-12-10 20:28:47
Dre Sahadeo
2018-12-10 20:34:24
Richard Shapiro
2018-12-10 20:37:25
Richard Shapiro
2018-12-10 20:39:01
Richard Shapiro
2018-12-10 20:43:02
Lonnie Ralfs
2018-12-11 02:21:43
Lonnie Ralfs
2018-12-11 02:46:30
Richard Shapiro
2018-12-11 02:47:42
Lonnie Ralfs
2018-12-11 02:49:44
Savio Ku
2018-12-11 02:56:41
Dre Sahadeo
2018-12-11 02:58:17
Richard Shapiro
2018-12-11 03:02:44
Richard Shapiro
2018-12-11 03:18:44
Lonnie Ralfs
2018-12-11 16:59:20
Savio Ku
2018-12-11 17:14:44
Lonnie Ralfs
2018-12-11 17:18:08
Savio Ku
2018-12-11 17:33:37
Lonnie Ralfs
2018-12-11 17:35:07
Savio Ku
2018-12-11 17:54:37
Lonnie Ralfs
2018-12-11 17:58:43
Lonnie Ralfs
2018-12-12 16:04:31
