Anycubic Photon Printer Owners 造訪社團 » 用戶發文

First big print. Spent 8 hours and a lot of resin on a solid Beholder the size of a lime. Tongue has a peg that locks into the base, but I think it will be too heavy and I should have hollowed it. Still have 10 tentacles to go.

翻譯年糕

I'm in Iowa and have a small townhouse with a connected/stacked 1.5 car garage where I'd like to eventually run my Photon, but not actively heated, so right now... it's cold. I'm getting my Photon today and will test it in my top 3rd floor office where it's about 72F and can set a small space heater next to it, but my question is: does anyone else put theirs in the garage and have a garage heater that does the job? If anything, it'll be an investment to help melt snow off my car, but would that not help enough? Am I SOL unless I can print somewhere it's closer to 80F?

翻譯年糕