Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Tom Delboo
2019-05-15 02:34:11

Hi All!
I printed my last print in two parts because it didn't fit in the print volume. Due to some warping quite a bit of work was needed to get both parts fit each other.

But now I would like to print a 40cmx40cmx25cm sculpture.
I started on dividing the model manually. But that's a lot of work so I was wondering if any of you have some tips on doing this quicker and great for assembly later on.

翻譯年糕

Philippe Maegerman
2019-05-15 02:40:58

Tom Delboo
2019-05-15 02:51:24

Philippe Maegerman
2019-05-15 02:59:42

原文網址 Tom Delboo
2019-03-18 16:14:43

Getting to the limits. Not of the printer but my own ability to clean the prints. After cleaning some parts broke off like the cord between totoro and miyazaki. So think I will split the print up in parts and make it overall a bit bigger.

翻譯年糕