Hi everyone, I'm having a lot of trouble getting things to print properly with Siraya Blu.
The recommendations in the spreadsheet say 10-12 sec layers and 30s for bottom layers. I had to go up to about 20s and 140s just to get things to stick. Also, it seems to be a pretty thin resin, though everyone says it's super viscous. I just built a heater and set it to 30C and preheated everything for 30 mins, but it didn't help. Tried a 12s print with it and it failed miserably.
Printer has only been used for about a week, with intermittent success (best was anycubic black, grey was awful). What do I try next? Replace fep? (it's showing some creases and dings)? Relevel build plate? (Thought I had it perfect). Everything I'm printing is mechanical parts, nothing organic.
翻譯年糕
Chris Diaz
2019-03-20 05:54:44
Alex Hoenig
2019-03-20 06:03:36
Alex Hoenig
2019-03-20 06:10:44
Vinicius Silva
2019-03-20 06:54:32
Alex Hoenig
2019-03-20 06:58:50
Vinicius Silva
2019-03-20 07:12:44
Alex Hoenig
2019-03-20 08:16:54
Alex Hoenig
2019-03-20 08:17:08
Vinicius Silva
2019-03-20 08:29:37
Alex Hoenig
2019-03-20 09:03:05
Vinicius Silva
2019-03-20 09:05:00
Robert Silvers
2019-03-20 09:49:00
Vinicius Silva
2019-03-20 09:52:48
Robert Silvers
2019-03-20 09:55:14
Alex Hoenig
2019-03-20 21:48:05
Alex Hoenig
2019-03-20 21:49:24
Alex Hoenig
2019-03-20 21:50:44
Alex Hoenig
2019-03-20 22:26:06
Vinicius Silva
2019-03-20 22:30:26
Vinicius Silva
2019-03-20 22:31:19
Vinicius Silva
2019-03-20 22:31:51
Vinicius Silva
2019-03-20 22:32:06
