Anycubic Photon Printer Owners 造訪社團 » 用戶發文

What do you think about the Phrozen Shuffle XL compared to the Photon?

I'm alright with my photon's capabilities, a few minor problems but all can be handled, however I would need something same as photon but with larger printer area. The shuffle xl seems to be what I'm looking for.

Someone mentioned here not long ago, that the small shuffle is more reliable than the Photon

What do you think what is the next step after the photon?

翻譯年糕

Chitubox scaling...??
First it seemed a z-axis distortion, but not.

Check the attached images, the left model is sliced with Chitu, the right is sliced with Anycubic's software. Both are printed with the same Photon, 5 bottoms at 55sec, normals at 18sec, layering: 0.05mm, Anycubic white resin.

When working with Chitubox, In both x and y, the print is scaled up by a factor of about 5%, and the z size stays at its original, I have given at the cad sw. This effect is not seen on the Chitubox's srceen, I have checked the scaling, if it has been set to anything else than 1.

Then I have realised the error can be fixed If I set the print area to the same as in the native Anycubic-slicer. My chitu settings was just 5% larger but in all three directions.

So how large is exactly the printing area of the Photon??
The softvare I've downloaded from anycubic is set to 68.04 x 120.96 x 150 mm

This is very interesting why chitobox is scaling the model If the print area is not set correctly, and why in only x and y, and not in z. I would think If a wrong size is set, it results a smaller area than the actual, or results a clipping if oversized.

Have you ever experienced similar with Chitu?

翻譯年糕