Hey guys. I'm really getting desperate here. I can't get a perfect print like i've seen you guys do. I always get random layer lines. I've checked a couple of similar post but i couldn't get an answer yet.
What i've done.
- Make sure every screw on the printer is well tightened specially the base plate, rail, motor and lead screw nut
- Lead screw is clean and greased
- FEP is tightened between 350hz and 375hz
I wanted to try and tighten the eccentric screw but i can't. I tried using a hot air gun but it doesn't move.
I think this might be related to the Z-Axis stability. Do you think twin linear rails upgrade will resolve this? Any chance i can do it without messing with the original rail (i'm almost certain i'll screw it up in the process)?
Here are some shots of the result and the model printed.
翻譯年糕
Nick Williams
2019-05-20 23:07:36
Ruben Rocha
2019-05-20 23:15:24
Nick Williams
2019-05-20 23:17:58
Ruben Rocha
2019-05-20 23:24:13
Robert Maefs
2019-05-21 00:43:38
Robert Maefs
2019-05-21 00:44:06
Robert Maefs
2019-05-21 00:45:45
Nick Williams
2019-05-21 00:46:32
Philippe Maegerman
2019-05-21 00:49:06
Ruben Rocha
2019-05-21 01:13:39
Ruben Rocha
2019-05-21 01:20:47
Chad Elstad
2019-05-21 06:55:39
Nick Williams
2019-05-21 07:04:39
Arri Merenda
2019-05-21 10:29:17
Ruben Rocha
2019-05-23 01:14:28
Nick Williams
2019-05-23 01:17:31
Ruben Rocha
2019-05-23 01:22:12
William Preston Welch
2019-05-23 02:21:44
Ruben Rocha
2019-05-23 02:28:37
