Anycubic Photon Printer Owners 造訪社團 » 用戶發文

PSA: when not printing for a little while....when you do start a job.....remember to screw in the vat.

That is all.

翻譯年糕

2 or 3 weeks ago someone posted their solution for a hand tool, like a Dremel tool, that they were using to sand the support points. Does anyone remember what that was? Thanks!

翻譯年糕

I just completed something I was dreading...the fep change.
Here is my review:
Dread- 8/10 before starting
Fun- 2/10 it’s a lotta screws
Sense of accomplishment: 10/10 looks good, sounds good.

Now to go see if it works!

翻譯年糕

Hello Everyone.
I have had some successful prints so far and have been watching the great advice and tips here.

I ran into a strange problem - printing 6 round based 28mm minis onto the plate. First print 4-6 printed flawlessly. The two that did not print just had the base and supports no model on them.
Tried again and got similar results. It seems like the models on the end of the plate are not adhering but i get the platform.

Is there a trick in Chitubox as to how close the model can be to an edge (the were inside the box in the software)?

Items in the middle of the plate always seem to come out great. It is just the sides of the plate that seems to loose the models or just print platform and support.

Looking forward to any advice!

Thank you All!!

翻譯年糕