Newbie question here - I have recently purchased a Photon S and my first print failed by not adhering to the build plate. My second attempt failed an inch into the build so i lowered the bed by 0.1 and my third print failed like in my first attempt.
Any ideas as to why this is happening?
?
翻譯年糕
Tom Franco
2019-04-25 01:49:02
Phil Lee
2019-04-25 01:50:46
Gary Houser
2019-04-25 01:54:16
Danny Lloyd
2019-04-25 01:55:18
Robb Nunya
2019-04-25 01:55:39
Tom Franco
2019-04-25 01:56:03
Phil Lee
2019-04-25 01:56:42
Danny Lloyd
2019-04-25 01:59:25
Silas Bo Nielsen
2019-04-25 02:27:23
Robert Silvers
2019-04-25 02:41:19
Phil Lee
2019-04-25 03:15:19
Robert Silvers
2019-04-25 03:17:46
Phil Lee
2019-04-25 03:24:36
Robert Silvers
2019-04-25 03:31:01
Phil Lee
2019-04-25 03:45:27
