Looking for some help troubleshooting a failed print. I’m a new photon user and it has been printing great for a week. Using anycubic green with default settings. Plate seems level and I haven’t had any adhesion problems. The supports look ok. Searched the group but didn’t find anything like this. Thoughts on what would cause this? Thanks in advance!
翻譯年糕
Mikko Asikainen
2019-04-28 22:51:23
Sam Charles Chaperz
2019-04-28 22:52:15
Chris Wainman
2019-04-28 22:53:40
Richard Webb
2019-04-28 23:01:34
Eriks Petriks
2019-04-28 23:06:00
Chris Wainman
2019-04-28 23:09:55
Dominick Trascritti
2019-04-29 00:11:06
Andrey Sabrev
2019-04-29 00:16:01
Andrey Sabrev
2019-04-29 00:18:39
Chris Wainman
2019-04-29 00:18:54
Chris Wainman
2019-04-29 00:19:15
Andrey Sabrev
2019-04-29 00:21:47
Andrey Sabrev
2019-04-29 01:26:28
