Hi everyone - We purchased a Photon a couple of weeks ago and the print results were great - very small holes (0.7mm) clearly defined with crisp edges when printed with included green resin and default settings. A week later the Photon S was available, so we got one of those to increase volume and expected improvements with the dual rail slide and new illumination. Again using the included green resin and default settings the results are much worse. Details look dull and poorly defined. Small holes are often completely missing. Leveling, Z=0 and adhesion is good. Any ideas on what might fix this? Thanks in advance!!
翻譯年糕
Michael Van Kesteren
2019-04-29 06:24:56
Danny Lloyd
2019-04-29 06:27:16
Alex Vee
2019-04-29 06:27:52
Jamie Chivers
2019-04-29 06:31:09
Patrick Nixon
2019-04-29 06:31:20
