Hi Everyone.
So I have finally started to test our printer and after levelling the machine and the build plate, these images are the result. Do you perhaps have any suggestions as to what you think might be going wrong?
Looking forward to your response.
Bob Deblier
2019-07-09 03:16:21
Armando Kerford
2019-07-09 03:18:59
Ola Lundin
2019-07-09 03:22:59
Tamás Lehoczky
2019-07-09 03:39:45
Ola Lundin
2019-07-09 03:43:32
Richard Bates Jr.
2019-07-09 04:32:10
Richard Bates Jr.
2019-07-09 04:36:19
Branko Savic
2019-07-09 06:47:38
Scott Pavlich
2019-07-09 11:31:05
Marna Kriel
2019-07-09 20:53:35
André Nettermann
2019-07-09 21:31:11
Richard Bates Jr.
2019-07-09 21:36:44
Marna Kriel
2019-07-09 22:02:36
Paul Mabbott
2019-07-10 01:51:57
Marna Kriel
2019-07-10 01:57:51
Marna Kriel
2019-07-13 20:09:04
Marna Kriel
2019-07-13 20:09:41
