Hi all, first time user that is in need of help. Yesterday Ran my first two prints. - both of the test cube that came with the printer. The first stuck to the FEP but I understand my mistake there.
I cleaned the printer and re-leveled (Flint Read method) and this time I paused the print them make sure it was sticking to the build plate. It was but the was a small strip of goo hanging from it. Not part of the model and not fully cured resin. I pulled it off with a pair of tweezers and decided to let the print finish.
This is what I awoke to this morning. Both pictures are of the same model, just rotated 90 degree. In addition t the print being messed up, there were 2 good sized layers of resin cured to be he FEP.
I'm looking for some advice as to what's going on here? Thanks in advance!
翻譯年糕
Kevin Boogaard
2019-04-22 21:58:25
Dustin Skye
2019-04-22 22:08:54
Scott Longberry
2019-04-23 06:57:23
Scott Longberry
2019-04-23 06:58:19
Dustin Skye
2019-04-23 07:16:25
Scott Longberry
2019-04-24 12:29:39
Jared Zadorozny
2019-04-24 13:43:35
Dustin Skye
2019-04-24 20:54:20
Scott Longberry
2019-04-25 20:08:32
