Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Seen lots of people on here with sub 10 second layer cure times.

I've found optimal settings for me with Monocure Rapid Clear at 14 seconds. Feel like I get better detail with 14.. and at 13 seconds and 3DPrintingPro's "micro supports" don't cure properly.

翻譯年糕

Hey crew, really struggling to print bases for miniatures that don't deform/warp.

Tried on an angle with not much success but happy to take any suggestions and try again. Ended up either warped and curled or stuck to my FEP (I imagine too much surface area caused supports to not be able to keep it from warping.)

Only success I have had is flat on the plate, hollowed with holes in the bottom which I imagine reduced suction force?

Thank you for this group I would not have ANY successful prints if not for browsing here.

翻譯年糕

Whats the temperature range for printed parts on a photon? And how can I ensure a printed part is food-safe?

翻譯年糕

Hello all, have recently bought a Photon after having owned an Ender 3 a little while. Few very successful prints on the photon, I mostly print D&D minis.. but the ones ive printed haven't needed supports.. so I'm looking for suggestions/tutorials on supports for minis when printing with resin.

翻譯年糕