Hi all, I'm at my wits end. I just bought a Photon. I've had two successful test prints using the test lattice cube with the included green resin.
I've tried several other prints like 3dbenchy and gargula, both fail to stick. I've tried re-levelling again, tested the cube again and the cube comes out great.
Does anyone have any other recommended test prints with known good settings? I'm using Chitubox for the slicer. I've read the FAQs and I'm not entirely convinced it's a levelling issue. Any help would be appreciated!
翻譯年糕
Hector Felix
2019-05-14 11:41:50
Brad Dudenhoffer
2019-05-14 11:42:52
Mata Mac Gille Fhionntain
2019-05-14 11:46:01
Stephen Farrell
2019-05-14 13:01:42
Michael Dills
2019-05-14 13:13:42
Arved Aasmaa
2019-05-14 19:39:27
Dominick Trascritti
2019-05-14 20:34:04
Richard Thomas
2019-05-15 00:00:27
Kevin Chang
2019-05-15 00:07:21
Sean Walsh
2019-05-15 03:55:45
Jacques Abbeels
2019-05-15 06:26:54
Patrick Nijkamp
2019-05-16 16:50:59
Jacques Abbeels
2019-05-18 13:05:38
Patrick Nijkamp
2019-05-21 20:52:41
Sean Walsh
2019-05-22 22:03:58
Kevin Chang
2019-05-22 22:53:02
Mark Wardle
2019-05-22 23:38:20
Mark Wardle
2019-05-22 23:39:03
Sean Walsh
2019-05-23 00:48:40
