Having troubles with my last 3 prints and looking for advice as I'm brand new to DLP printing.
Using the Anycubic Green resin that came with the printer.
The supports print fine but the model itself always ends up stuck to the bottom. Settings and model attached. I just switched to Chitubox and didn't have these issues before using the photon slicer.
翻譯年糕
Damian Thomas Strong
2019-05-24 22:02:38
Philippe Maegerman
2019-05-24 22:06:01
Regan Fairbanks
2019-05-24 22:06:29
Damian Thomas Strong
2019-05-24 22:08:32
Artur Kawa
2019-05-24 22:17:37
Michael McElrath
2019-05-24 22:29:46
Damian Thomas Strong
2019-05-24 22:31:39
Damian Thomas Strong
2019-05-24 22:32:19
Michael McElrath
2019-05-24 22:38:00
Gary Houser
2019-05-24 22:43:14
Artur Kawa
2019-05-24 22:47:17
Michael McElrath
2019-05-24 22:50:16
Michael McElrath
2019-05-24 22:50:41
Joel Reid
2019-05-24 23:43:28
Damian Thomas Strong
2019-05-24 23:47:46
Chris Rees
2019-05-24 23:56:02
Andy Chung
2019-05-25 00:27:38
Eric Green
2019-05-25 02:06:11
Eric Green
2019-05-25 02:07:35
Damian Thomas Strong
2019-05-25 02:18:00
Gary Houser
2019-05-25 04:12:43
Gary Houser
2019-05-25 04:16:38
Joao Claudio
2019-05-25 10:51:25
Damian Thomas Strong
2019-05-25 10:54:21
Damian Thomas Strong
2019-05-28 07:34:41
