Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Sam Davey
2020-04-02 15:47:34

Woke up to a failed print. Turned the machine off to clean the vat and build plate and now it wont turn back on. Strange. Power supply light still on but the machine will not power up at all. Any ideas before i pull this c@nt apart and stick my big fingers in places they shouldn’t be?

Is there a thermal fuse that may reset if i leave it?

Is there a fuse on the main board i can change?

Has this happened to anyone else?

翻譯年糕

Richard Pigott
2020-04-02 15:55:35

I had something similar with a dodgy usb stick

Sam Davey
2020-04-02 15:56:06

Richard Pigott took the stick out and still wont power up. This was my first thought

Matthew Sengstock
2020-04-02 21:13:42

Not to sound silly but did you unplug it and plug it back in?

Sam Davey
2020-04-02 21:14:09

Matthew Sengstock yes.

原文網址 Sam Davey
2020-03-10 02:13:55

Changed screen. Then this. Am i right in saying screen is defective

翻譯年糕

Mongo Rogers
2020-03-10 02:15:27

Sam Davey
2020-03-10 02:18:43

Sam Davey
2020-03-10 02:19:02

原文網址 Sam Davey
2020-01-14 03:20:03

Anyone got anycubics support email screens gone again and contacting them on there page dont work as there not replying

翻譯年糕

Evan Boone
2020-01-15 05:09:48

原文網址 Sam Davey
2019-10-25 07:51:45

Clear yellow is on offer. Anyone ever use it? I tried aqua blue before and ended up sending it all back don’t wanna make the same mistake

翻譯年糕

原文網址 Sam Davey
2019-08-07 06:34:12

Ok same file, same usb, same level method. Print on one machine and it’s fine try on another and shit fails. Keep getting a thinner base layer in the middle of my build plate. I thought this was my fan cooling the middle to much and causing my resin to fail but last night I turned it off and got the same failure.

So I cleared build plate, re-levelled. Printed fine but the build plate is now so close that I am marking and I am guessing going to pierce my FEP again (the whole reason why I re-levelled again and made it a bit further away).

So I guess the question is Un-even build plate? Don’t have access to a straight edge or any proper measuring device that would answer that question for me. But I can’t see any other reason for the failures.

翻譯年糕