So I am a new user with the Photon, I've had it for about 2 days now. I've calibrated it... tightly, to the single sheet of paper. My first test print was the photon cube and it printed perfectly but then at the very end I heard a pop and the last 3-4mm of the cube looked like it ripped off into the vat.
I've since noticed that even though I tightened the calibration screw as tight as I can, there is still like a 10 degree rotation along the horizontal plane (only along this axis) that the plate can wiggle back and forth with slight effort. Did I somehow tighten the screw "wrong" or is this like a manufacturing tolerance issue that won't affect my prints. Would this have affected the adhesion issue mentioned above? Thanks so much!
翻譯年糕
Richard Shapiro
2019-07-02 07:04:14
Chad Elstad
2019-07-02 07:05:51
Robert Mun
2019-07-02 07:07:18
Jason Ehrenman
2019-07-02 07:14:08
