Finally got started doing some prints with the AnyCubic Photon. I had to replace the FEP right out of the gate since it arrived with several small dents and what appeared to be a wrinkle. AnyCubic is sending a replacement, and the installation of one of the spares that came with the printer went smoothly. I printed Monocure test disk as the first print and it came out quite good. I'm currently printing the test cube from the sample file that came with the printer. That appears to be going well, but I did have a question. I noticed about half way though the print that the model "wobbled" a small bit when popping off the FEP. But from what I can see it still is looking good. So I wondered if it is normal for a slight movement of the lattice cube to happen during printing? Note it appears to be well attached to the build plate.
翻譯年糕
Chad Elstad
2019-07-16 11:37:34
Burt Bicksler
2019-07-16 21:55:48
Burt Bicksler
2019-07-16 21:56:15
Chad Elstad
2019-07-17 00:48:40
Burt Bicksler
2019-07-17 07:36:32
Burt Bicksler
2019-07-17 07:38:23
Chad Elstad
2019-07-17 07:45:29
Burt Bicksler
2019-07-17 07:47:44
Chad Elstad
2019-07-17 08:41:11
Burt Bicksler
2019-07-18 04:12:34
Burt Bicksler
2019-07-18 22:15:12
