I just downloaded ChiTuBox to try it out, configured the printer and resin. Went on doing supports and then slice.
Popped the USB into my photon but it does not seem to recognize it as a "valid" photon file.
Any suggestions on this?
The save format is .photon, resin and printer settings is same as on the photon slicer. The file just show up as a "text file" on the printers screen while the ones from the other slicer shows a preview.
?
翻譯年糕
Regan Fairbanks
2019-08-09 17:35:26
Bob Deblier
2019-08-09 17:42:34
Chad Elstad
2019-08-09 21:04:30
Conny Karlsson
2019-08-09 22:50:53
Billy Thiex
2019-08-10 01:17:02
Nicolas Tsagarides
2019-08-10 13:10:08
Billy Thiex
2019-08-10 13:45:25
