Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi everyone is there a Schematic or wiring diagram for the photon mainboard?

After about 20 days of installing the new mainboard (after the stock one died), and only 4 prints this one died as well. Again great service from Anycubic, made the ticket on monday, yesterday they shipped a new one, but needless to say I have lost a good deal of confidence in their components.

Plus it takes the thing about two months to arrive.

So a friend who works in the electronics world, offered to take a crack at fixing any of the dead mainboards

I'm collecting, but said a schematic would help a lot.

Thanks

翻譯年糕

So my mainborad died and Anycubic sent a new one, I installed it today and went for tried printing, which it did without problem.

But I noticed the buildplate, vat, and the screen were hot (this being the source of the heat).

This didn't happen with the original board and I was wondering if might connected some wires wrong (didn't seem like it when I checked). Or it is within nomality?

翻譯年糕

If there´s a cold war wargamer around, you might find this interesting. It seems there will be Warsaw Pact, Vietnam War and anglo zulu war kickstarters in the nearby future. https://www.kickstarter.com/projects/245117264/cold-war-german-bundeswehr/description 翻譯年糕

Hi everyone! I'm new at lcd printing, but I've read a lot of the groups experiences and I've learned a ton.
But... I would like to know if there is a way to print flat on the plate. I have a few waterline ships and printing them at an angle leaves a really messy bottom...
But my attemps have been unseccesfull.
It's at 1:2400 scale. Printed at 100 microns (test prints). In wanhao grey.
Does anyone has a suggestion to printing flat?
Thanks!!

翻譯年糕