Hey there, new user here, been getting failed benchy's while the anycubic test cube prints fine. Apparently it sticks to the buildplate for the first couple of layers before it falls off resulting in that larger subsequent layers. May I know if its likely that the bed is not close enough to the FEP? (leveled flint read method) Rather puzzled, thanks for any kind advice!
翻譯年糕
Michael James
2019-10-07 20:44:06
Adam Green
2019-10-07 20:49:01
Dan Andersson
2019-10-07 21:13:27
Sheng Wei
2019-10-07 21:14:13
Sheng Wei
2019-10-07 21:14:31
Sheng Wei
2019-10-07 21:14:58
Dan Andersson
2019-10-07 21:15:55
Mike Wind
2019-10-08 02:30:20
Sheng Wei
2019-10-08 02:43:01
Sheng Wei
2019-10-08 02:43:30
Edgar Anderson
2019-10-08 12:20:03
Sheng Wei
2019-10-08 12:34:35
