Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I bought an cabinet set up and a carbon filter/fan to limit the toxic fumes prior to my first print. (Wife and two small toddlers).

I need some advice. My thinking was to have the fan positioned in the section with the printer then blowing into the carbon filter in the yellow section.

Would it be better to have the fan suck in air through the carbon filter and extract that air out?

The printer cabinet will be lined so when the doors are shut it will be air tight as much as possible.
I have looked into the attachment for the printer to connect the pipework but I figure that the printer cabinet can hold any resin contaminated material and as such I decided that it would be better to have the whole section ventilated.

I do have the option of venting outside but this is positioned in the loft and as such the window will be tricky to get watertight as it's a roof window which is tilted in the middle.
Also we most likely will moving and I would like to find a solution which is self contained as much as possible.

Any advice would be appreciated before I go cutting 4 inch holes into the sections.

翻譯年糕