Hey everyone, I have a question perhaps related to slicer software.
I am currently using the Anycubic Photon in a lab setting where we would like to add a small amount of material to the resin bath/print between layers, rather than fill the bath with resin.
Is there a way in the AnyCubic slicer to set the off POSITION as well as the off time? Ideally we would like the build plate to fully retract between layers so that we may easily add a small amount of material between each exposure/layer.
Our models are very small in the z-direction so we just need to add a few droplets of our viscous resin between each layer. Currently the build plate only retracts a small distance, and we are unable to access the area of the resin bath between each layer.
If you have any suggestions or knowledge on this, I would greatly appreciate it. Thanks!
翻譯年糕
Clint B. Kauffman
2019-09-04 10:07:14
Ed Tackett
2019-09-04 10:11:22
Tom Pattison
2019-09-04 10:17:45
Tom Pattison
2019-09-04 10:21:07
Clint B. Kauffman
2019-09-04 10:25:56
