dear Community, I printed this with following settings.
Why is it making an eggshape on top???
it should be round like the bottom and the right side (its on the photo not good to see) its a little bit flat not curved - on the right side was the support....
should I print it in an angle X that the eggshape does not happen?
bottom all other shapes are perfect just the nipple is an egg
?
?
.why?
I am not sure of the print settings on the photo I might changed the off time to 5 an normal exposure to 12?
But I am not sure.. I cannot check, at the moment I am at work. but I will update as soon I am at home...
Thanks in advice
翻譯年糕
Christopher Ashworth
2019-10-25 14:33:40
Tiago Carita
2019-10-25 14:37:23
Kalia Herbststurm-Fyrstin
2019-10-25 14:38:46
Kalia Herbststurm-Fyrstin
2019-10-25 14:40:05
Kalia Herbststurm-Fyrstin
2019-10-25 14:44:23
Kalia Herbststurm-Fyrstin
2019-10-25 15:28:57
Vlad Trofimovskiy
2019-10-25 15:56:13
Kalia Herbststurm-Fyrstin
2019-10-25 16:20:11
Jackson Luck
2019-10-25 17:05:00
Kalia Herbststurm-Fyrstin
2019-10-25 17:13:12
Aleksey Kulagin
2019-10-25 17:15:32
Kalia Herbststurm-Fyrstin
2019-10-25 17:30:59
