Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I just got my Photon over the weekend-I was able to print out the test file fine and had a print failure due to orientation. I fixed the orientation of the object and I keep getting failed prints since then (Sticking to the fep, pulling/falling off the build block) of the same object two times. I’m using Elegoo Grey for my prints.

I’m wondering if temperatures are my issue-my basement is about 63-65 degrees F and it was warmer Sunday when I had the successful print.

Any suggestions?

翻譯年糕