• 3D列印服務
  • COSPLAY 3D 建模
  • #maker+t=market
  • 1
  • 2
  • 3

Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Nathan Inwin
2019-09-16 13:31:07

A thank you post to the group. Thanks for getting me over the hurdles I've experienced so far.

Print success but design failure. Made it too thin and slight. Couldn't get the supports off without breaking it. I am pretty amazed at the detail of the print though.

I'm also going to change how I do supports. Balls might look like a good idea in the slicer, but they are probably only really useful for larger, tougher prints where you can remove them more aggressively.

翻譯年糕

Nathan Inwin
2019-09-16 13:53:49

Chamberlain Skeksil
2019-09-16 14:50:10

Aaron Strome
2019-09-16 16:34:27

Daniel James Menk
2019-09-18 11:47:19


原文網址 Nathan Inwin
2019-09-15 11:10:05

What causes these transparent thin bits to form off the edge of the print? There are also some inside the cube as well.

翻譯年糕

Sean McAndrews
2019-09-15 11:12:43

Nathan Inwin
2019-09-15 11:13:18

Sean McAndrews
2019-09-15 11:14:02

Nathan Inwin
2019-09-15 11:14:47

Sean McAndrews
2019-09-15 11:15:16

Nathan Inwin
2019-09-15 15:29:53

Sean McAndrews
2019-09-15 15:30:48

Tiernan Messmer
2019-09-15 20:55:41

Nathan Inwin
2019-09-16 02:13:50

Nathan Inwin
2019-09-16 02:14:43


原文網址 Nathan Inwin
2019-09-15 03:08:35

Test cube. File from the anycubic website on a new USB. I've tried both paper leveling and Flint Read. This is my third failure. It seems to go good until it reaches the middle of the cube.

Any idea on what I should try next?

翻譯年糕

Graham Rust
2019-09-15 03:18:16

Nathan Inwin
2019-09-15 15:26:20


 

討論主題

全不選 常用關鍵字