Anycubic Photon Printer Owners 造訪社團 » 用戶發文

May be the type of resin. Opaque resins take way longer to cure then translucent or transparent. I use Elegoo Gray and sometimes my models are a little sticky. Throw it in the curing chamber for another hour or two and that seems to do the trick.

Funnily enough, I was about to make the same post. I'm experimenting with Siraya blu clear and it feels tacky after ultrasonic cleanse. I use mean green as well, then dunk in warm water to rinse before curing.

Because you are using a detergent rather than a solvent to clean your parts. If you are using detergent, you have to scrub more, and some resins are more resistant than others.

Omar Silva - Siraya specifically recommends solvent cleaning for all of their resins.

Omar Silva I am using siraya blue also

Try a final rinse in gold, er IPA.

I had this problem with abs-like resins. Curing them in water solved the issue.

Jim Nelson so
You submerge them
In water then put the cup in front of your UV light ?

Jason Pacheco I have done that, but more frequently I just put them in a clear plastic tub of water out in the sun. That solves two problems, the prints get cured and the water gets disposed of through evaporation.