So first major fail. Any idea what the fault is.
With my limited knowledge I would say it's either:
Firmware
Screen
FEP
Bad Luck
When I look closer at the model it looks like the pieces are supports that have broken off and then squished itself.Did I have to many supports?
When I do the screen test it looks ok,
Firmware is 4.2.3,
The Fep is a bit wobbly/wavy in one part, but I've done other prints ok and it's still taught,
Something I've noticed with the Resin I use Wanhao Water Washable Grey (and no I do not flush the water down the drain I handle it the exact same way I would IPA) is that the resin and the pigment(?) separate themselves if the sit, even during printing is this something I need to worry about?
EDIT: There was also some stuck resin on the bottom, and this is why I think some supports broke of, it could just be that I missed and island. I am pretty sure I got the all though.
翻譯年糕
Bob Deblier
2019-10-20 16:09:07
Pascal Pacman Blomquist
2019-10-20 16:14:31
Bob Deblier
2019-10-20 16:26:40
Pascal Pacman Blomquist
2019-10-20 16:33:03
Bob Deblier
2019-10-20 16:54:43
Pascal Pacman Blomquist
2019-10-20 17:07:06
Pascal Pacman Blomquist
2019-10-20 17:12:34
Tiernan Messmer
2019-10-20 21:37:38
Tiernan Messmer
2019-10-20 21:38:40
