Hi all, I'm a little unsure of a problem I'm having with prints coming out lopsided (think leaning Tower of Piza) and with slight layer shift.
I follow the original Anycubic bed levelling procedure (with the piece of paper) shown here.
However, once I've got good resistance on the piece of paper and tighten the grub screw, once I raise the build plate, the build plate can wobble both on the x/y axes and the z axis. Is that correct, or should it be rigidly flat and unable to move?
Just wondering if a wobbly build plate is causing my print issues?
翻譯年糕
Michael Garza
2019-10-02 06:30:43
Robin Young
2019-10-02 06:33:01
Michael Garza
2019-10-02 06:35:06
Robin Young
2019-10-02 06:36:24
Michael Garza
2019-10-02 06:36:48
Robin Young
2019-10-02 06:37:25
Robin Young
2019-10-02 22:32:07
