Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone have an idea what might be happening here? Getting extra pieces of resin on prints, lines in the prints, not finishing parts or not printing at all. Lots of extra chunks floating in the vat. Also one looked like it was cooked in half. I've adjusted the fep, replaced it, leveled leveled leveled, cleaned and strained the resin. Updated firmware, tried a new USB stick.. It just started doing this really bad recently. Lcd looks like it's working OK. Forgot to add:this is a 90 second bottom layer 15 second normal. Also tried everywhere up to 110 bottom with no change.

翻譯年糕

Question for you guys. I've been reading up on here and applying as much as I can to get successful prints. I've leveled and leveled and leveled again. When I change out my fep sheet, I get about 5 good prints out of it then I can not for the life of me get one successful after that. It always sticks to the build plate but fails and sticks to the fep after a bit. I re level check tension, clean everything up, still no dice. I change the fep out, Works great for 4 to 5 more prints then same thing. I'm using elegoo black, didn't have this issue with gray on my first liter of resin. I've went through at least 4 fep sheets in the last month. Even tried the non fep sheets. Tried different exposures, different bottom exposures, lcd test looks good. I just tried printing something 5 times and it failed every time. Replaced fep, prints great lol. Any ideas? 80 second bottom exposure with 8 layers, 12sec normal. Was at 15 and had the same issue. Thanks in advance

翻譯年糕